Combo Tool

Combination of Integral Blade Stabilizer and Roller Reamer

Provides gauge protection with enhanced stabilization value for directional control

Key Seat Wipers

In high angle holes, an indention or slot appearing on the high side of the wellbore, can develop.

This condition can prohibit BHA components from passing through the hole.

TRIUMPHS Keyseat Wiper utilizes a mandrel and sleeve with tungsten carbide dressed blades.  When a keyseat is detected, the tool is raised or lowered to engage, rotate, and cut the obstruction, thus allowing full clearance for drill collars and all BHA components.

Available "clutched" or "fixed" blade type.

Square and Tri-sided Drill Collars

Triumph's Square and Tri-sided Drill Collars are run in packed hole assemblies to reduce rapid changes in crooked hole formations.  While both afford the needed rigidity to accommodate weight on bit requirements to achieve desired rates of penetration, the Tri-Sided Collar design allows for enhanced fluid circulation and less potential for differential sticking.  Square drill collars are available in hole sizes 6 inches thru 17 1/2 inches.  Tri-Sided drill collars are available in hole sizes 6 inches thru 12 1/2 inches